ERROR invalid keyword: CAThumbprint

View thread

peggers

Hey everyone!

I'm attempting to use the om_ssl module on an NXLog Community Edition but checking the logs at "C:\Program Files (x86)\nxlog\data\nxlog" showed the following message: "ERROR invalid keyword: CAThumbprint"

After not finding anything about the error above, I decided to use a combination of CAFile, CertFile, CertKeyFile and KeyPass on the Output configuration which worked but I'd rather use the CAThumbprint directive. What am I doing wrong?

Output tag from the "C:\Program Files (x86)\nxlog\conf\nxlog.conf" looked like this: <Output out> Module om_ssl CAThumbprint xxxxxxxxxxxxxxxxxxxxxxxxxxxx # numbers and letters, without spaces Host 10.0.0.10 # representative IP Port 1514 Exec to_syslog_bsd(); </Output>